Advertisement
Quick Links
USER MANUAL ............................................................
BEDIENUNGSANLEITUNG ........................................
MANUAL DE USUARIO ..........................................
MANUALE DI ISTRUZIONI ...........................................
MODE D'EMPLOI ........................................................
seite 12
page 36
Advertisement
Related Manuals for Hitachi CM1785ME
Summary of Contents for Hitachi CM1785ME
- Page 1 COLOUR MONITOR FARBMONITOR 17MVX MONITOR EN COLOR MONITOR A COLORI CM1785ME MONITEUR COULEUR USER MANUAL ............page 2 BEDIENUNGSANLEITUNG ........seite 12 phgina 20 MANUAL DE USUARIO .......... MANUALE DI ISTRUZIONI ........... Pag 26 MODE D’EMPLOI ............page 36...
- Page 2 - F E A T U R E S The following features are provided by the HITACHI Colour Monitor CM1785ME. Automatically scans between 30 kHz and 64 kHz horizontally, 50 Hz and 100 Hz vertically. Wide compatibility range of graphics standards, VGA, XGA, 8514/A, Super VGA, Macintosh II Video Card, 1,024 x 768 non-interlaced and 1,280 x 1,024.
-
Page 3: Table Of Contents
Colour Monitor CM1785ME Operating Guide CONTENTS CAUTION ................OPERATION LOCATION OF USER CONTROLS, CONNECTIONS AND INDICATORS ......INSTALLATION ............COMPATIBILITY ............SPECIFICATIONS ............TRADEMARK ACKNOWLEDGMENT IBM PC, PC/XT, PC/AT, Personal Systems/2, VGA, and 8514/A are registered trademarks of International Business Machines Corporation. Apple and Macintosh are registered trademarks of the Apple Computer, Inc. -
Page 4: Caution
(CAUTION) NEVER REMOVE THE BACK COVER Removal of the back cover MUST be carried out only by authorized service personnel. This display monitor contains high voltage components. DO NOT USE IN HOSTILE ENVIRONMENTS DO NOT expose this display monitor to rain or moisture to prevent electric shock or fire hazard. -
Page 5: Electrical Connection
For U. K. Customers THIS PRODUCT IS SUPPLIED WITH A TWO PIN MAINS PLUG FOR USE IN MAINLAND EUROPE. FOR THE U. K. PLEASE REFER TO THE NOTES ON THIS PAGE. NOTE: ELECTRICAL CONNECTION Your monitor requires an electrical supply of 240 volts - 50 Hertz and should be protected by a 5 amp fuse. - Page 6 As the colours of the wires in your mains lead in this equipment may not correspond with the markings identified with the terminals of your plug, proceed as follows: The wire which is coloured Green and Yellow must be connected to the terminal in the plug which is marked with the letter E or by the symbol or coloured Green or Green and Yellow.
-
Page 7: Operation
OPERATION LOCATION OF USER CONTROLS, CONNECTIONS AND INDICATORS (FRONT VIEW) 1. Power Switch : Power ON and OFF 2. Degaussing Switch : Activate degaussing 3. Contrast Control : Adjust foreground brightness 4. Brightness Control : Adjust back ground brightness 5. Horizontal Position : Adjust display location horizontally 6. -
Page 8: Installation
00000 I , “j (REAR VIEW) 9. AC Inlet: Power cord connection 10. BNC connectors : Red, Green and Blue video signals and optional H/V sync or H sync and V sync shall be connected here. INSTALLATION Follow these procedures for first time installation. Make sure the Power Switch is off. - Page 9 BNC connectors : Connect double shielded coaxial cables with BNC connector at the monitor ends. This monitor has five (5) BNC input connectors, however, number of cables required depends on the graphics board sync signal output. Sync on Green signal : Three (3) cables H/V composite signal : Four (4) cables H, V separate signal : Five (5) cables If the graphics board supplies more than one type of sync signal, use...
-
Page 10: Compatibility
COMPATIBILITY -Y - CM1785ME is compatible with most of the analog output graphics boards available for PC, PC/XT, PC/AT, P.S/2, Macintosh II series and compatibles. CONNECTION PIN ASSIGNMENT BNC connectors There are five (5) BNC connectors on the rear side of cabinet. They are following order from the left to right. -
Page 11: Specifications
( SPECIFICATIONS > 17 (16 V) inches diagonal, 0.28 mm dot pitch, Black matrix, Silica coated, Short persistence. Input signal Video : 0.7 Vpp, Analog : Separate H, V or Composite H/V sync TTL level or Sync on Green at 0.3 Vpp Synchronization Horizontal : 30-64 kHz : 50-100 Hz...