Antenna Connection - Hitachi 22LD5750U User Manual

Antenna connection

Note: Before you connect other appliances:
• To avoid potentially damaging your set, make sure all items are switched off and disconnected from the
mains power when you make the connections.
• Arrange the desired connection.
• When you have finished making the connections, reconnect the mains power to the unit and switch it
back on.
Connect your antenna as shown below (J). Connections to other equipment is explained further on
P.41~43. If you have problems with reception, consult a specialist of antenna.
(A) Power supply: Connect the supplied power cable to an AC 220-240V/50Hz mains power supply
only - do not attempt to connect it to any other type of supply. Never try to repair a damaged AC
power cord with insulation tape - this should be repaired by a specialist or replaced. Do not let your
pet loose near the cable. Animals biting into the cable could receive a fatal electric shock, and could
cause a hazard to others.
(B) HEADPHONE jack: Plug headphones with a mini plug (3.5 mm) into this jack.
(C) COMPONENT input: See P.43.
(D) AV2 input: Input for analogue AV-Signal (Composite or S-Video). See P.43.
(E) DVB-T Digital audio output: digital output for CD/DVD & DVB-T (see page 42).
(F) PC MONITOR input (PC): See P.39.
(G) PC/HDMI AUDIO input: See P.39, 40.
(H) HDMI input : See P.40.
(I) Scart socket (AV1): For the connection of scart cable. See P.41~43.
(J) ANT: Plug in the antenna (aerial) here.
(K) C.I. slot: for DVB-T-PayTV (see page 22).
(L) Bracket holes: Fix a wall mounting bracket (not supplied) here.
(M) To hang the television on a wall, remove these screws and then remove a stand.
Before performing work spread cushioning over the base area to lay the TV on.
10
Back Side
(L)
(M)
(A) (B) (C) (D) (E) (F) (G) (H)
(K)
(J)