Fitting The Hob Into The Worktop - Zanussi ZGF 780 IT Instruction Booklet

Fitting the Hob into the Worktop

Carry out the building in of the hob as follows:
• place the seals supplied with the
hob on the front edge of the cut
out. Then, place them at 86 mm
from the side edges and at 10 mm
from the rear edge, as shown in
the diagram, taking care that the
seals meet without overlapping.
• place the hob in the cut out, taking
care that it is centred;
• fix the hob with the relevant fixing
clamps, supplied with the
accessories bag, as shown in the
diagram. When the screws have
been tightened, the excess seal
can be removed.
The edge of the hob forms a double seal
which prevents the ingress of liquids.
20
Seal