Installation Instructions - Zanussi ZBM 799 Operating Instructions Manual

Installation Instructions

It is mandatory that all operations
for the installation of this cooker be
carried out by qualified and compe-
tent persons to the relevant British
Standards.
The manufacturer declines all
responsability if safety regulations
are not strictly observed.
Electrical Connections
The oven is designed to be connected to
220-240V (50Hz) electricity supply. The
oven has an easily accessible oven block
which is marked as follows:
Letter L - Live terminal
Letter N - Neutral terminal
- Earth terminal
THIS APPLIANCE
EARTHED
The cable used to connect the oven to the
electrical supply should have the characteri-
stics indicated in the table.
It is necessary that you install a double pole
switch between the appliance and the electri-
city supply (mains), with a minimum gap of
3 mm between the switch contacts and of a
type suitable for the required load in com-
pliance with the current rules.
The switch must not break the yellow and
green earth cable at any point.
Important
After installation and connecting, the cable
must be placed so that it cannot at any point
reach a temperature of more than 50°C or
above the ambient temperature.
MUST BE
Before the appliance is connected, check
that the main fuse and the domestic installa-
tion can support the load; and that the power
supply is properly earthed.
The manufacturer disclaims any responsabi-
lity should these safety measures not be car-
ried out.
This appliance meets the requirements laid
down in EEC Directive No. 89/336 relating
to the suppression of radio and TV interfe-
rence.
Model Rating
ZBM 2,685
799X
Insertion into Modular Furniture
For built-in appliances it is necessary that
furniture has suitable dimensions;
dimensions of the oven, of the space and
instruction for insertion and assembly follow
(Fig. 8). Compliance with safety regulations
protection against contacts with electrical
parts must be assured by a correct insertion
of the appliance. All safety relevant parts,
even a possible covering panel (if an
appliance is placed at the end or at the
beginning of a row of furniture) must be
fixed in a way that it is impossible to remo-
ve them without using tools. In modular fur-
niture plastic material layers and veneered
would should be treated with glue resistant
to a temperature of 85°C. Plastic materials
or glues not resistant to this temperature can
cause deformations or ungluing.
Please ensure that when the appliance is
installed it is easily accessible for the engi-
neer in the event of a breakdown.
Cable Cross
Section mm2
and type of cable
1,5
Ho5 RR-F
Fuse
Min.
13A
41