Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for AEG 502 D
Summary of Contents for AEG 502 D
- Page 1 502 D Extractor Hood Installation and Operating Instructions...
-
Page 2: Table Of Contents
Contents Electrical connections ... 4 Safety warnings for electricians ... 4 Appliances with 2 wires ... 5 Safety warnings for kitchen unit installer ... 6 General details ... 7 Extractor version ... 7 Filter Version ... 8 Description of the appliance ... 9 Technical details ... -
Page 3: Electrical Connections
Electrical connections Safety warnings It must be ensured that the voltage and current indicated on the for electrician rating plate agree with the voltage of the user to electricity supply. If the appliance has been equipped with a mains lead with a moulded-on type plug, the following regulations must be comply with: The plug moulded on to the lead incorporates a fuse. -
Page 4: Appliances With 2 Wires
Electrical connection for the UK The appliance must be connected to fixed wiring with a double pole switched fused spur outlet with or without pilot lamp. We strongly recommend the appliance to be connected only by a qualified electrician who is a member of the NICEIC who will comply with the IEE and any local regulations. -
Page 5: Safety Warnings For Kitchen Unit Installer
Safety warnings When the unit is used in its extractor version, a sufficiently large for kitchen unit ventilation hole must be provided, with dimensions that are installer approximately the same as the outlet hole. The air outlet must not be connected to chimney flues or combus- tion gas ducts. -
Page 6: General Details
When used as an extractor unit, the hood must be fitted with a 100mm diameter hose. If the fumes must be forced out through the wall, you must obtain a MKZ sizable wall exhaust pipe (with external exhaust and air intake), E-Nr.- 610 899 004 (Ø... -
Page 7: Filter Version
Filter version Cooking vapours are cleaned by the charcoal filter (Special accessories) and ducted back into the kitchen. The AEG original KF-Plus charcoal filter is necessary for the recirculating mode (see paragraph “Special accessories”). For the recirculating mode proceed as follows: a) Remove the grid by turning knob A (fig. -
Page 8: Description Of The Appliance
Description of the appliance 1) Light switch 2) Motor switch 3) Work surface lamp 4) Grid Technical details Model 502 D Net weight: 5 kg Height 145 mm Width 520 mm Depth 285 mm Absorbed power: 160W Motor: 1 x 120 W... -
Page 9: Fixing The Hood
Fixing After having adjusted the hood for the version required, it may be installed. the hood This appliance is designed for fitting in a cabinet or some other support. The opening to be made on the bottom of the wall-hung cabinet must correspond with the measurements shown in fig. -
Page 10: Safeting Warnings For User
The hood is fitted with one variable speed motor. The most effective use of the hood is obtained by switching it on a few minutes before you start cooking and leaving it on a for approximately 5-15 minutes after having finished, thus ensuring that all that cooking odours are eliminated. -
Page 11: Hood Operation
Hood Operation Controls The hood is fitted with a variable speed motor. The most effective use of the hood is obtained by switching it on a few minutes before you start cooking and leaving it on a for approximately 15 minutes after you have finished, thus ensuring all cooking odours are eliminated. -
Page 12: Care And Maintenance
Care and Maintenance Before performing any maintenance operation, disconnect the hood from the electricity. The hood has a metal grease filter. To clean the filter, proceed as follows: Open the grill by turning knob A (fig. 2). Pull the two plastic stops B as shown by the arrows (fig. 5) and remove the metal filter. -
Page 13: Charcoal Filter
Charcoal The charcoal filter must be changed at least every 4 months. filter The charcoal filter cannot be washed or regenerated. The hood can only work well in the recirculating mode if the AEG recommended filter has been used, the filter is changed as recommended in this section and if the hood is cleaned and maintained as instructed in this booklet. -
Page 14: Replacing The Lamps
Always turn off the electricity before replacing lamps! 1) Remove the grid (Fig. 2) in order to check the lamps and replace them if necessary. 2) Unscrew the lamps that do not work and replace them with 40W max lamps (E14). If the light does not function, check that the lamps are properly screwed before contacting a customers’... -
Page 15: Special Accessories
Special accessories See AEG price-list for wallbox and hose accessories. KF-Plus charcoal filter E-Nr. 942 118 620 Technical assistance service You are welcome to telephone our technical assistance service (see list of technical assistance centres) whenever you need information or in the unlikely event of a fault. When calling, please be ready to specify: 1. - Page 16 AEG Hausgeräte AG Postfach 1036 D-90327 Nürnberg © Copyright by AEG L 650A H 259 226 140...