Stored In The Facsimile Machine; A2.5 Updating Paper Feeding Correction Value Stored In The Facsimile Machine - Brother MFC5200C Service Manual

A2.5 Updating Paper Feeding Correction Value

Stored in the Facsimile Machine

To keep the paper feeding performance in the best condition for quality print, the controller
optimizes the rotation of the paper feed roller and paper ejection roller, using the correction value
stored in the EEPROM of the driver PCB.
If you replace the paper feed roller, paper ejection roller, print head unit, or driver PCB, then you
need to update the paper feeding correction value according to the procedure given here.
TIP: The updating procedure given here needs entry to the maintenance mode. Refer to
CHAPTER 7, Subsection 7.5.14.
Connecting the facsimile machine to your PC
(1) Make sure that your PC is turned off.
(2) Make sure that the power cord of the facsimile machine is unplugged from a wall socket or
other power source.
(3) Connect the interface cable to the parallel interface port on the back of the facsimile machine
and secure it with the lock wires.
(4) Connect the other end of the interface cable to the printer port of your PC and secure it with
the two screws.
Setting up the facsimile machine and your PC
(1) Install the printer driver for the parallel port to your PC. (Once installed, no more printer
driver is required for your PC.)
(2) Copy the "PFROLL_CHECK.PRN" onto the desired directory of the hard disk.
(3) Copy the transfer utility "Filedg32.exe" onto the desired directory of the hard disk.
(4) Run "Filedg32.exe."
The Filedrgs window will appear as shown below.
Ap p . 2 -9