Configuring Gigabit Ethernet Ports; Assigning Gigabit Ethernet Port Names - Cisco WS-C2948G-GE-TX Configuration Manual

Chapter 5 Configuring Gigabit Ethernet Switching
Table 5-10 Gigabit Ethernet Default Configuration (continued)
Feature
Native VLAN
Spanning tree port cost
Gigabit EtherChannel

Configuring Gigabit Ethernet Ports

The following sections describe how to configure Gigabit Ethernet switching ports on the Catalyst
enterprise LAN switches.
Note For information on configuring Gigabit EtherChannel, see
and Gigabit EtherChannel."

Assigning Gigabit Ethernet Port Names

You can assign names to the ports on Gigabit Ethernet modules to facilitate switch administration.
To assign a name to a port, perform this task in privileged mode:
Task
Step 1
Assign a name to a port.
Step 2
Verify that the port name is configured.
This example shows how to assign the name for ports 2/1 and 2/2 and how to verify that the port names
are configured correctly:
Console> (enable) set port name 2/1 Backbone Connection
Port 2/1 name set.
Console> (enable) set port name 2/2 Wiring Closet
Port 2/2 name set.
Console> (enable) show port 2
Port
----- ------------------ ---------- ---------- ------ ------ ----- ------------
2/1
2/2
<...output truncated...>
Last-Time-Cleared
--------------------------
Tue Dec 22 1998, 13:42:04
Console> (enable)
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2948G-GE-TX, and Catalyst 2980G Switches Software Configuration Guide—Release 8.2GLX
78-15908-01
Default Value
VLAN 1
4
Disabled on all Gigabit Ethernet ports (auto mode)
Name Status
Backbone Connectio connected
Wiring Closet notconnect 1
Chapter 6, "Configuring Fast EtherChannel
Command
set port name mod_num/port_num [name_string]
show port [mod_num[/port_num]]
Vlan Level Duplex Speed Type
trunk normal full
normal full
Configuring Gigabit Ethernet Ports
1000 1000BASESX
1000 1000BASESX
5-7