Accessing The Aic - Cisco MWR 1941-DC - 1941 Mobile Wireless Router Software Configuration Manual

Chapter 6 Configuring the MWR 1941-DC in a Cell Site DCN
Configure IP routing to the AIC without an unnumbered IP address, beginning in global
configuration mode:
Command
Step 1
Router(config)# interface serial slot/port
Step 2
Router(config-if)# ip address ip-address
network-mask
Step 3
Router(config-if)# exit

Accessing the AIC

Remote-CLI and local-CLI are the two methods for accessing the AIC:
•
•
Table 6-3
Slot Number
0
1
2
3
4
5
6
OL-11503-01
Remote-CLI involves telneting to the IP address of the AIC. For example:
telnet 10.5.5.2
Local-CLI involves accessing the asynchronous craft port by telneting to the IP address of the router
and the AIC's TCP port number. For example:
telnet 10.2.130.105 2001
where 10.2.130.105 is the router's IP address and 2001 is on slot 0 of the AIC.
The AIC's TCP port number depends on the slot number in which the AIC is installed. As shown in
Table 6-3, the Cisco IOS software reserves the first line of each slot for the asynchronous craft port.
TCP Port Number Allocation for the AIC on the Cisco 2600 and Cisco 3600 Series
Terminal Line Number for the AIC's Asynchronous Craft Port
1
33
65
97
129
161
193
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
Configuring the NM-AIC-64, Contact Closure Network Module
Purpose
Enter the serial interface mode. Enter the slot in
which the AIC is installed and the port 0.
Specify the IP address and mask of the router's serial
interface to the AIC. For example:
Router(config)# ip route 10.5.5.1
255.255.255.0
Exits the serial interface mode.
TCP Port Number
2001
2033
2065
2097
2129
2161
2193
6-29