Rear Spacers - AEG 210621236-11052010 User Manual

3 Brown:
5 Blue:
As the colours of the wires in the mains lead of this appliance may not correspond with
the coloured markings identifying the terminals in your plug, proceed as follows:
1. Connect the wire coloured green and yellow to the terminal marked either with the
letter "E" or by the earth symbol
2. Connect the wire coloured blue to the terminal either marked with the letter "N" or
coloured black.
3. Connect the wire coloured brown to the terminal either marked with the "L" or col-
oured red.
4. Check that no cut, or stray strands of wire is present and the cord clamp
over the outer sheath.
5. Make sure the electricity supply voltage is the same as that indicated on the appli-
ance rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug fitted
the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used.
WARNING!
A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure
that it is disposed of safely.

Rear spacers

In the bag with the documentation, there
are two spacers which must be fitted as
shown in the figure.
Slacken the screws and insert the spacer under
the screw head, then tighten again the screws.
Live
Neutral
or coloured green and yellow.
2
. In the event of having to change
3
17
Installation
4
is secure
2
1