Adjusting The Direction Of Air Circulation - Fujitsu AWYZ14LBC Operating Manual

ADJUSTING THE DIRECTION OF AIR CIRCULATION

G Adjust the up, down, left, and right air directions with the AIR DIRECTION buttons on the Remote Controller.
G Use the AIR DIRECTION buttons after the Indoor Unit has started operating and the airflow-direction louvers have
stopped moving.
Vertical Air Direction Adjustment
Open the lid on the Remote Controller.
Press the AIR DIRECTION (Up-Down) button. (Fig. 5
G When the AIR DIRECTION (Up-Down) button (Fig.5
direction changes within the range to the following.
G You can select the desired airflow direction.
Cooling/Dry range
Air flow-direction
louvers
Power diffuser
* The up/down airflow-direction louvers move in the
G
* The Remote Controller
display does not change.
Right-Left Adjustment
Open the lid on the Remote Controller.
Push the AIR DIRECTION (Left-Right) button (Fig.5
G When the AIR DIRECTION (Left-Right) button (Fig.5
direction will change in the following order.
s Front airflow s Right airflow
Left airflow t Front airflow
G You can select the desired airflow direction.
G The Indoor Unit is set for front airflow when the unit
is turned on.
) is pushed, the airflow
Heating range
direction of the arrow from the closed position.
In order to maximize the heating and cooling
performance, use the ranges above.
Fan range
) is pushed, the airflow
t
* The Remote Controller
display does not change.
R DANGER!
G Never place fingers or foreign objects in-
side the outlet ports, since the internal fan
operates at high speed and could cause
)
personal injury.
About airflow direction adjustments
G When the unit is turned on or the op-
eration mode is changed, the position
of the airflow-direction louvers is au-
tomatically set as listed below to match
the operation mode (heating, cooling,
etc.) selected.
Cooling/Dry/Fan:
Heating: downward airflow
G During HI-POWER operation (see page
12), the up/down airflow direction is set
automatically to optimize the heating
and cooling performance.
G When the AIR DIRECTION buttons on
the Remote Controller are pressed, it
may take a short time for the up/down
airflow-direction louvers or the left/
right airflow-direction louvers to reach
the desired position.
During that time, the airflow direction
cannot be adjusted even if the AIR DI-
RECTION buttons are repeatedly
pressed.
G During the monitor period in the auto
mode (see page 7), horizontal airflow
direction is set and cannot be adjusted.
G If the AIR DIRTCTION (Up-Down) but-
ton is pressed during the up/down
swing operation (see page 11), the up/
down swing operation will stop. In
addition, if the AIR DIRECTION (Left-
Right) button is pressed during the left/
right swing operation, the left/right
swing operation will stop.
).
horizontal airflow
En-8