Initializing The Ub-R03 - Epson C32C824461 - UB R03 Print Server Technical Reference Manual

Initializing the UB-R03

The UB‐R03 setting can be reset to the default using the following method.
1
Set a roll paper for the TM printer to print.
2
Turn off the TM printer.
3
While holding down the Push button, turn the TM printer on.
Push the Push Button using an extended paper clip or a pen point.
4
Wait about 10 seconds without letting the Push button up. A receipt as
shown below is printed.
Do not turn the printer off until the initialization is completed.
5
After about 20 to 25 seconds, a message notifying the completion of
initialization is printed.
6
After the completion message, a Dynamic Status Sheet is printed.
Chapter 2 Installation
Push Button
2
45