Table of Contents
Advertisement
Real time clock error
Previous boot incomplete - Default configuration
used.
Memory size found by POST differed from CMOS.
Diskette drive A error
Incorrect Drive A type - run SETUP
System cache error - Cache disabled
CPU ID
DMA Test Failed
Software NMI Failed
Fail-Safe Timer NMI Failed
Device Address Conflict
Allocation Error for device
Failing Bits: nnnn
Fixed Disk n
Invalid System Configuration Data
I/O device IRQ conflict
Operating system not found
Error Message List
No beep Error Messages
No beep, power-on indicator turns off and LCD is
blank.
Chapter 4
Error Messages
FRU/Action in Sequence
RTC battery
Run BIOS Setup Utility to reconfigure system time,
then reboot system.
System board
Run "Load Default Settings" in BIOS Setup Utility.
RTC battery
System board
Run "Load Default Settings" in BIOS Setup Utility.
DIMM
System board
Check the drive is defined with the proper diskette
type in BIOS Setup Utility.
See "External Diskette Drive Check" on page 70.
Check the drive is defined with the proper diskette
type in BIOS Setup Utility.
System board
System board
DIMM
System board
DIMM
System board
DIMM
System board
Run "Load Default Settings" in BIOS Setup Utility.
RTC battery
System board
Run "Load Default Settings" in BIOS Setup Utility.
RTC battery
System board
DIMM
BIOS ROM
System board
None
BIOS ROM
System board
Run "Load Default Settings" in BIOS Setup Utility.
RTC battery
System board
Enter Setup and see if fixed disk and drive A: are
properly identified.
Diskette drive
Hard disk drive
System board
FRU/Action in Sequence
Power source (battery pack and power adapter).
See "Power System Check" on page 71.
Ensure every connector is connected tightly and
correctly.
Reconnect the DIMM
LED board
System board
75
Advertisement
Table of Contents
