Required Tools; Customer Replaceable Units; Field Replaceable Units - Dell PowerVault 130T DLT Service Manual

Required Tools

Required Tools
The following tools are required for some removal/replace procedures and must be
provided by the customer:

Customer Replaceable Units

Customer Replaceable Units (CRUs) are designed to be removed/replaced by an
individual with minimal technical experience. Follow all precautions and
instructions.
Table 3–1.
Units
DLT drive tray
assembly

Field Replaceable Units

Field Replaceable Units (FRUs) are to be removed/replaced only by technically
trained service personnel.
Table 3–2.
Units
CYC card
CYO card
(operator panel
assembly)
DLT Drive Tray
Assembly
Electronics
module
Hand/camera
assembly
3–4
Flashlight
Torx screwdriver
Wire clipper
CRU Locations and Functions
Locations
Left rear of the
library
FRU Locations and Functions
Locations
Part of the
electronics module
(EM)
Front of the
library, above the
CAP.
Left rear of the
library
Right rear of the
library
Attaches to the
bearing block on
the Z column
PowerVault 130T Service Manual
Functions
Holds tape drive and its power
supply
Functions
Microprocessor that monitors
and controls all functions of
the 130T library.
Displays library and drive
statuses. Used for configuring
the system, running
diagnostics, and examining
errors.
Holds drive assembly for
read/write operations
Houses the power supply,
CYC card, fan assemblies
Mounts and dismounts
cartridge tapes from storage
cells and tape drives.
Page #s
3–13
Page #s
3–6
3–8
3–13
3–19
3–25
4473D