Honeywell 5804BD User Manual

About 5804BD
5804BD is a four-button remote control for your alarm system. 5804BD can send a command to the alarm system,
such as to arm or disarm, as well as receive system status. Two LEDs and a speaker are used to indicate system
status. 5804BD is typically used for arming, disarming, and controlling devices. Check with your installer to
understand which functions the buttons have been assigned on your unit.
Operating the Buttons
Activating a Button
To activate a function, press and hold the appropriate button down until the yellow LED flashes (2 beeps will be
heard), and then release it.
NOTE: Transmission will not be successful if the key is not within range of the system's receiver. If 5804BD does
not receive system status from the panel for approximately five seconds, it will generate a long (one second) beep.
Requesting System Status
You can check system status before arming or disarming your system.
Check the system status by momentarily pressing and releasing any button. The yellow LED will flash after you
release the button (one beep will be heard). After a second or two, the device will display the system status
through the LEDs and speaker (see the System Status Indications Table, below). If 5804BD does not receive
system status from the panel for approximately five seconds, it will generate a long (one second) beep and shut
itself down. It will also shut itself down if you do not press a button within five seconds of receiving a status update.
LED LED Condition
Red On Steady
On Steady
Flashing
Flashing
Flashing
Yellow (right) Flashing
Red & Green Alternately Flashing
Green On Steady
Flashing
Flashing
Flashing
Multiple Button Operations
The 5804BD can generate the same responses as
keypad key pairs of [*] + [#] and [*] + [1]
depressing "A" + "C" and "B" + "D" button pairs,
respectively. You must depress the button pair for
at least 2 seconds for the 5804BD to recognize the
button pair command. These button pairs allow you
to activate additional keypad functions depending
on control panel programming. Check with your
installer to understand which functions the buttons
have been assigned on your unit.

USER GUIDE

System Status Indications Table
Sounds
2 Beeps
3 Beeps
Pulsing
Steady
Silent
Silent
Silent
1 Beep
Silent
Pulsing
1 Beep
by
TWO-WAY WIRELESS KEY
System Status
Armed Away or Maximum
Armed Stay or Instant
Fire Alarm in progress
Armed, Burglary Alarm in progress
Alarm Memory
Indicates RF transmission
In Enter House ID Mode
Disarmed, Ready to Arm
Disarmed, Not Ready to Arm
System in Trouble Condition
System Not Ready
N8547V1 04/09
5804BD