Follow Instructions To Avoid Interference Problems; Medical Devices; Exposure To Radio Waves - Motorola ELECTRIFY M Getting Started Manual

• When placing or receiving a phone call, hold your mobile device just like you
would a landline phone.
• If you wear the mobile device on your body, ensure that the device is
positioned at least 2.5 cm (1 inch) away from the body, and if you use an
accessory case or holder, ensure it is free of any metal.
RF Energy Interference/Compatibility
Nearly every electronic device is subject to RF energy interference from external
sources if inadequately shielded, designed, or otherwise configured for RF
energy compatibility. In some circumstances, your mobile device may cause
interference with other devices.

Follow Instructions to Avoid Interference Problems

Turn off your mobile device in any location where posted notices instruct you to
do so, such as hospitals or health care facilities.
In an aircraft, turn off your mobile device whenever instructed to do so by airline
staff. If your mobile device offers an airplane mode or similar feature, consult
airline staff about using it in flight.

Medical Devices

If you have a medical device, including an implantable medical device such as a
pacemaker or defibrillator, consult your healthcare provider and the device
manufacturer's directions before using this mobile device.
Persons with implantable medical devices should observe the following
precautions:
• ALWAYS keep the mobile device more than 20 centimeters (8 inches) from
the implantable medical device when the mobile device is turned ON.
• DO NOT carry the mobile device in the breast pocket.
• Use the ear opposite the implantable medical device to minimize the
potential for interference.
• Turn OFF the mobile device immediately if you have any reason to suspect
that interference is taking place.
Specific Absorption Rate (IEEE)
SAR (FCC & IC)
YOUR MOBILE DEVICE MEETS THE
GOVERNMENT REQUIREMENTS FOR

EXPOSURE TO RADIO WAVES.

Your mobile device is a radio transmitter and receiver. It is designed and
manufactured to not exceed limits for exposure to radio frequency (RF) energy
set by the Federal Communications Commission (FCC) of the U.S. Government
and by the Canadian regulatory authorities. These limits are part of
comprehensive guidelines and establish permitted levels of RF energy for the
general population. The guidelines are based on standards that were developed
by independent scientific organizations through periodic and thorough
evaluation of scientific studies. The standards include a substantial safety