Table of Contents
Advertisement
3.9 Automatic Recovery Function
The TM-U230 models feature a function for automatic recovery when the power
is turned on again after an interruption of power. Recovery processing is
performed automatically when the printer's power is turned on again after an
interruption. The recovery processing restores the printer to the condition it was
in before the power was turned off.
3.10 Output without Flow Control on the USB/Ethernet Interfaces
The TM-U230 models support outputting without flow control on the
USB/Ethernet interfaces. The operations differ by the firmware versions. See the
section 2 "2.1 References of Firmware Versions" of this manual.
3.11 Delayed Cut Function
The TM-U230 models are equipped with a delayed cut function. This function is
used to delay cutting position of the receipt when the present printing location
coincides with the receipt cutter. Once the function is set, delayed cutting is
done automatically.
The Delayed cut function is accessed via the DirectIO PTR_DI_DELAYED_CUT
command. The receipt will be fed and the cut will occur in a location of 4mm + x
where x is the value of pData * 0.176mm (pData/144 inches). The default value
of pData is "0" and the valid values range from 0 to 255.
The Delayed Cut function is cancelled by pressing the [Paper Feed] button or by
executing a command that causes the printer to reset.
14
APPLICATION DEVELOPMENT GUIDE
POSPrinter (TM-U230)
Version 2.61 Feb. 2008
Advertisement
Table of Contents
