Density Setting; Adding Slant To Text - Brother MacBroidery„ Embroidery Lettering Software for Mac Instruction Manual

40 MacBroidery™ Embroidery Lettering Software
2 Click on the arrows button
You see a list of patterns.
3 From the Pattern list, select a pattern.
4 Click Apply.
The fill of your text segment will be accordingly.

Density Setting

Satin stitch density is measured in embroidery points (pts). This is
measured as the distance between stitches (each point = 0.1 mm).
You adjust density according to the design's size and the fabric you
are using.
To make a density change to a segment:
1 With the Select tool, select the segment.
2 In the density field, enter a new density value; higher numbers
correspond to lower density, lower numbers correspond to higher
density.
3 Click the Apply button.
The density will be applied to the selected segment.

Adding Slant to Text

Use the Slant setting to create a slanted effect for your lettering. Slant
changes the degree value of the slant on your lettering. A negative
value slants your lettering to the left; a positive value slants it to the
right.
To add slanted effect:
1 Select the text segment.
2 Select the Properties panel to display the Text properties.
3 In the Slant field, enter the amount slant you want for your lettering.
The slant is given in degrees, with straight up-and-down being
considered as zero degrees.
4 Click Apply.
You see the lettering altered accordingly.
on the right of the Pattern field.