English - Panasonic PT-VX400NTU Operating Instructions Manual

The focus assist bar will display different colors ac-
cording to the clarity of image.
Color state
Red The projected image is turning unclear.
Yellow The projected image is turning clear.
Blue The projected image is optimal.
Attention
When the easy setting function is started, the focus
z
assist bar does not display blue color, even if the
focus adjustment is optimal. So readjust the focus
with rotating the focus ring.
5 ) Then press the <SELECT> button on the
remote control or on the control panel.
The adjustment image of [Screen fit] appears.
z Screen frame detected
If it detects a screen frame, [Screen Fit] function
is activated, the projected image is corrected to fit
the screen frame.
Adjust the image to fit the screen according to the
[Screen fit] function's different state.
The aspect ratio of image will change
On 1
to fit the screen.
The aspect ratio of image will not
change, and no image area will
On 2
appears in top/bottom sides or left/right
sides.
Then the [Colorboard] function is activated to get
an optimal image. [Corner correction] appears
and it can be adjusted manually if it is necessary.
( Æ page 37)
It will exit without any operation.
z Screen frame undetected
If it does not detect a screen frame, the [Keystone
(Standard)] function starts to work and the
projected image can be adjust horizontally and
vertically.
Then the [Colorboard] function is activated to get
an optimal image. [Keystone (Standard)] appears
and it can be adjusted manually if it is necessary.
It will exit without any operation.
The conditions of [Screen fit] function to adjust the
projected image as follows.
items conditions
Projected image
30" - 100" (after correction)
size
Distance between approx. 0.7 to 3.5 m (when
projector and execute the keystone function,
screen less than 2.5m)
approx. 20° right and left /approx.
Correction angle
30° up and down
0.7~3.5m
20°
Attention
If the [Focus assist], [Screen fit] and [Colorboard]
z
functions are working, do not move the projector or block
the image. The projected image will not be corrected
properly.
Please adjust the [Corner correction] or [Keystone
z
(Standard)] manually, if you want to correct the projected
image after the adjustment of [Screen fit]. (
Note
[Screen fit] corrects the projected image when it detects
z
two or more sides inside the projected area, and fits the
detected frame.
[Screen fit] may not work well in bright environments and
z
the projected image is in low contrast. In this case, make
the room darker, and then try executing [Screen fit] again.
Because [Screen fit] uses a sensor, it may not work
z
properly depending on the condition of the projection
surface (deflections, patterns, and so on), the distance
between projector and screen, or the effects of outside
light such as fluorescent. In this case, make the
adjustments manually.
It is recommended to use a black frame screen when
z
using [Screen fit] function.
When the easy setting function does not complete,
z
mark will be displayed.
Projecting
( Æ page 37)
30°
20°
Æ
page 37)

ENGLISH -

35