Table of Contents
Advertisement
Setting up Your LCD TV/Monitor
Connecting Your LCD TV/Monitor
DC
POWER VIDEO AUDIO(ST)
Figure 2. Cable connections
1. Connecting
A. Connect the power cord to the DC Adaptor and connect the adaptor jack to the DC 14V
power connector on the back of the TV/Monitor.
B. Connect the 15-pin D-SUB of the video signal cable to the PC video connector on the
back of the TV/Monitor.
C. Connect the stereo audio cable to "Audio (ST)" on the back of the TV/Monitor and the
other end to " Audio Out" terminal of the sound card on your computer.
D. If
necessary, install
driver installation, please refer "Installing Video Driver" section on page 6.
2. Connecting External A/V Devices (
A. Connect RCA audio cables to "Audio (R)" and "Audio (L)" terminals and the other ends
to corresponding audio out terminals on the A/V device.
(Stereo-RCA Cable not included)
B. Connect RCA (Yellow) or S-VHS cable to an appropriate external A/V device such as
VCR, DVD or camcorder. (RCA cable and S-VHS cable not included)
C.
Headphones
TV/Monitor (
in speakers will be disabled.
3. Connecting
A. Connect the YPbPr DTV Cable to the
TV/Monitor.
Connect the RCA Cable to
and the other end to "Audio out" terminal of the Set-Top Box.
4. Connecting TV/CATV (
A. Connect an antenna or CATV Cable to the antenna terminal on the back of the
TV/Monitor.
5. Connecting
A. Connect
TV/Monitor.
PC
COMPONENT2 DTV
Y
Pr
AUDIO(L) AUDIO(R)
Pb
DTV Settop Box
a
Computer (
1
2
3
TV/Monitor driver contained on the
may be connected to the headphone output on the right-hand side of the
). While the
headphones are
6
a
DTV Set-Top Box (
"Audio (L)" and "Audio (R)" Component 2(DTV) Audio
)
10
a
DVD (
) - Component 1
11 12 13
YPbPr and Audio R/L Cables from the DVD Player to the Component 1(DVD) jacks
RF
Y
COMPONENT1 DVD
Y
Pb
Pr
)
)
4
5
connected, the sound from the built-
) - Component 2
7
8
9
YPbPr Component 2(DTV) jacks on the
English
5
supplied
CD. For
jacks on the back of the TV/Mo
a
on t
Advertisement
Table of Contents
