Installation; Execution - Epson C323011 - TM J2000 B/W Inkjet Printer Installation Manual

Installation

Perform the installation by executing the Package File in the destination computer. Execute from
the Command Prompt. It is also possible to install it from a programmed MS-DOS Batch File.
Note:
If executed from Windows, the installation is performed without any options. The installation is
automatic followed by a Windows reboot.
If the Package File is created with "Uninstall TM/BA/EU drivers installed in the target PC"
checked and if there is an already installed driver with the same name as one of the drivers to be
installed, reboot is performed twice.
No status bar is displayed during execution.
When copying the Package File to a computer where the APD is already installed, first uninstall
the existing APD, reboot the computer then perform the installation.

Execution

The procedure for executing the Package File from the command prompt is as follows.
1. Copy the Package File to the destination computer.
2. Run "Command Prompt" from [start] - [All Programs] - [Accessories].
3. Enter the Package File path and name then press the Enter key . Enter parameters as
required. (See page 3-6)
The command line is as follows.
> Path Package name [Destination IP address] [Log file name] [Whether or not to
reboot] [Window handler of destination of result notification] [Notification
message ID]
Mandatory parameters
Path: Path to the executable file
Package name: File name of the package to execute
Rev.B
Advanced Printer Driver Installation Manual
Silent Installation 3-5