Yamaha Arius YDP-V240 Owner's Manual page 117

8
Set the adjuster.
8-1
Rotate the adjuster until it comes in firm con-
tact with the floor surface.
9
Attach the headphone hanger.
9-1 Install the headphone hanger using included
two screws (4 x 10mm) as shown in the figure.
■ Remove the protective tapes
Open the key cover and remove the protective tape
on each side of the keyboard.
■ After completing the assembly, please
check the following.
• Are there any parts left over?
➔ Review the assembly procedure and correct any errors.
• Is this instrument clear of doors and other movable
fixtures?
➔ Move the instrument to an appropriate location.
• Does this instrument make a rattling noise when you
shake it?
➔ Tighten all screws.
• Does the pedal box rattle or give way when you step
on the pedals?
➔ Turn the adjuster so that it is set firmly against the floor.
• Are the pedal and power cords inserted securely into
the sockets?
➔ Check the connection.
• If the main unit creaks or is otherwise unsteady when
you play on the keyboard, refer to the assembly dia-
grams and retighten all screws.
CAUTION
• When moving the instrument after assembly, always hold the
bottom of the main unit.
Do not hold the key cover or top portion. Improper handling
can result in damage to the instrument or personal injury.
Do not hold here.
Hold here.
Keyboard Stand Assembly
117
Owner's Manual