Sony HMZ-T2 Reference Manual page 35

Symptom
When the system is off,
video and audio from the
playback equipment is not
played on a TV connected
to the HDMI OUT jack
"Control for HDMI" on a TV
cannot be used to control
the playback equipment
even when the system's
HDMI pass-through is used
Head mounted unit buttons
are unresponsive
"DEMO" appears in the
upper-right corner of the
setting menu screen
Cannot adjust "Language
setting" because the
setting menu is in an
unfamiliar language
Cause/Action
p Confirm that the HDMI cables are fully connected.
p Set "HDMI pass-through" in "General Setup" to "On" (page 26).
p Switch the input source on the TV to this system.
p Check the HDMI output settings on the playback equipment.
p Refer to the instruction manual supplied with your TV, and in the
TV's "Control for HDMI" setting, specify playback equipment
connected to the processor unit as the controlling device.
p Buttons on the head mounted unit do not function unless you are
wearing it.
p Contact your Sony dealer or local authorized Sony service center.
p If initial setup is not finished, press the b button repeatedly to
return to the language selection screen, and then select your
preferred language again.
p If you have finished initial setup, follow these steps to restore the
system to the original, factory settings and specify the correct
language.
1 Press the MENU button to display the setting menus.
2 Press the V button and select
3 Press the B button and move the cursor to the right.
4 Press the V button and move the cursor to the bottom setting.
5 Press the MENU button. (A "Reset to factory settings"
confirmation message is displayed.)
6 Press the b button, and then press the MENU button. (The
system will restart.)
7 After the initial setting screen is displayed, press the v/V
buttons to select your preferred language, and then press the B
button.
8 Follow the instructions displayed to finish initial setup.
(the "General Setup" icon).
35