Installing a SD Card
Media memory cards are generally marked with a symbol (such as a triangle or
an arrow) or a label to indicate which end to insert into the slot. The cards are
keyed to prevent incorrect insertion. If card orientation is not clear, see the
documentation that came with the card.
NOTE:
To use an SD card with your sled, ensure that the SD card slot is enabled in
the System Setup program. See "Using the System Setup Program" on page 55.
1 Hold the SD card with the label side facing to the right. See Figure 3-21.
2 Press the card into the slot to lock into place. See Figure 3-21.
If you encounter too much resistance, do not force the card. Check the
card orientation and try again. See Figure 3-21.
3 Slide the sled into the chassis until the sled is fully seated and the release
lever snaps into place.
Sled Covers
Remove the sled covers to access internal system components. To open sleds
with or without the front-access 2.5-inch hot-plug hard-drives, see "Removing
the Front and Back Sled Covers" on page 161. To open sleds with GPGPU
cards, see "Removing the Sled Cover" on page 166.
Removing the Front and Back Sled Covers
CAUTION:
The sled must be operated with the covers installed to ensure proper
cooling.
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
NOTE:
It is recommended that you always use a static mat and static strap while
working on components in the interior of the system.
NOTE:
Before you access the front cover, you must first remove the back cover
from the sled.
Installing System Components
161