Additional Rinse; Installation; Location; Connecting The Drain Hose - Samsung SWT50B1 Owner's Instructions Manual

ADDITIONAL RINSE

1 After rinsing you can select this
course for more effective rinse
(Don't just select this course
for rinse.) Load the laundry
evenly into the spin basket.
2 Set the WATER SELECTOR
KNOB to SPIN and
Wash Spin
CYCLE SELECTOR
KNOB to 'DRAIN'.
WATER SELECTOR
3 Supply water for about 1 minute.
Adjust the water flow to prevent
overflow from the wash tub.
4 After completing the water supply,
cover the laundry with
inner lid
safety cover and close
safety
cover
the inner lid.
5 Close the spin dryer lid.
0
6 Set the SPIN DRY
5 1
TIMER 2~3 minutes.
4
2
3
SPIN DRY TIMER

INSTALLATION

LOCATION

Leave some space of
at least 15cm between the washing machine
and the wall.
Place the washing machine on a sturdy flat
surface.
If the washing machine is placed on an uneven
or weak surface, noise or vibration may occur.
(Allowable is 2˚)
Never install the washing machine near water.
Do not place the washing machine in steamy
rooms or where the washing machine is directly
exposed to rain. Moisture may damage electrical
insulation and cause an electrical shock to occur.
Avoid direct sunlight or heating devices.
As plastic and electrical components are
affected by direct heat, never place the washing
machine near heaters, boilers, etc., or under direct
sunlight.
Install the drain hose
about 70~80cm above
the ground for pump model.

MOUNTING THE LEGS

Lay down the washer with its back facing
downward. Insert four legs into the leg mounting
sections of the base corners of the main body.
Insert the claw of the Claw
leg with the square
hole of the leg
2
mounting section, 1
and push the leg in
the arrow direction
as shown in the
Leg
figure until it clicks.
4
CHANGING THE POSITION OF THE
DRAIN HOSE
Before attempting to change the position of the
drain hose, disconnect the plug from the outlet.
1. Route the drain hose inside the machine.
2.Take out the drain hose from the opposite hole
and insert the drain hose into the hose holder.
1

CONNECTING THE DRAIN HOSE

After attaching the connector ring(a), insert
the drain hose(b) in the draining direction.
a
b
CONNECTING THE DRAIN HOSE
1. Before connecting the drain hose, remove
the cover (a) from the drain hole.
2. After pressing the joint ring (b), insert the
drain hose(c) to drain direction.
Square
hole
(C) (C)
(b)
(In case of pump
Bottom face of
drained washer)
main body
2
Hose holder
(a)
(b)