Tuner Operations; Tuning To Radio Stations; Presetting Radio Stations; Using The Plug And Play - Philips LX8500W/69 User Manual

Tuner Operations

IMPORTANT!
Make sure the FM and MW
antennas are connected.

Tuning to radio stations

1
Press SOURCE control to select
"TUNER FM" or "TUNER MW".
2
Press 34 briefly on the remote.
➜
"SEARCH" appears.
➜
The next radio station will tune
automatically.
3 2
Repeat step if necessary until you find
the desired radio station.
4
To tune a weak station, press S /
T briefly and repeatedly until an
optimal reception is found.
G
If the FM station reception is weak, you
can switch the FM mode from stereo to
mono. Press SURR button will toggle
through:
DOLBY PL II FM ST (stereo)
™ DOLBY PL II FM MONO
™ STEREO FM MONO
™ STEREO FM ST
36
001-045-LX85-69-Final

Presetting radio stations

You can store up to 20 FM and 10 MW
preset radio stations in the memory.
Helpful Hints:
– The system will exit presetting mode if no
button is pressed within 20 seconds.
– If no valid frequency is detected during
Plug and Play,"CHECK ANTENNA" appears.

Using the Plug and Play

Plug and Play allows you to store all
available radio stations automatically.
AUTO INSTALL PRESS PLAY
1
For first time setup, press SOURCE
on front panel to select TUNER mode.
➜ "AUTO INSTALL PRESS PLAY"
appears.
2
Press 2; on the top panel to start
installation.
➜ "INSTALL TUNER" appears.
➜
Once complete, the last tuned radio
station will play.
➜
FM followed by MW bands will be
stored.
36
2 1
3139 115 23231
24/08/2004, 10:48 AM