Table of Contents
Advertisement
Register the setup codes for your audio and video components
2
Step 1
Look up the setup code for the component you want
to control.
Write down all the applicable setup codes.
(This step is very important.)
Step 2
Hold down POWER key and press
POWER
the numeric keys to enter the 3-digit
setup code for the component.
Proceed to the next step within 15
seconds.
1
2
3
4
5
6
7
8
9
0
+10
Step 3
Press the source POWER (TV,
POWER
VCR/CDR, DVD) key for more than
TV
2 seconds to select the input you
VCR/CDR
registered.
Make sure if you can turn the com-
ponent on and off. (If the compo-
DVD
nent you want to control has a me-
chanical power key that cannot be
operated by remote control, press
the 6 key or the TUNING 1/
¡ key to test it.)
RC4
Repeat steps 2 and 3 to enter the codes for each compo-
nent you want to control.
If the component does not respond when you try to
control it, return to step 2 and enter the next setup
code on the list. Repeat this procedure until you find
the code that matches the component.
If you accidentally exit the registration mode by pressing the
wrong key, you will not lose any setup codes you have
already saved.
Quick Start Guide
Advertisement
Table of Contents
