Configuring IPv6 Routing Features (CLI)
This section provides information about the commands you use to configure
IPv6 routing on the switch. For more information about the commands, see
PowerConnect M6220/M6348/M8024/M8024-k CLI Reference Guide
the
support.dell.com/manuals.
Configuring Global IP Routing Settings
Beginning in Privileged EXEC mode, use the following commands to
configure various global IP routing settings for the switch.
Command
configure
ipv6 unicast-routing
limit
ipv6 hop-limit
ipv6 icmp error-interval
burst-interval
burst-
[
size
]
exit
show ipv6 brief
Purpose
Enter global configuration mode.
Globally enable IPv6 routing on the switch.
Set the TTL value for the router. The valid range is 0 to
255
Limit the rate at which IPv4 ICMP error messages are sent.
burst-interval
•
— How often the token bucket is
initialized (Range: 0–2147483647 milliseconds).
burst-size
•
— The maximum number of messages that
can be sent during a burst interval (Range: 1–200).
Exit to Privileged EXEC mode.
View the global IPv6 settings for the switch.
Configuring IPv6 Routing
at
1071