Basic Operations; Turning On The Power - JVC DLA-M4000LU - D-ila Projector Instructions Manual

Basic Operations

Projector's buttons
STAND BY indicator
OPERATE indicator
STAND BY OPERATE LAMP
OPERATE button
1, 2
MAIN POWER switch
Remote control unit
QUICK
ALIGN. OPERATE
AV HIDE
PRESET PAGE BACK
AV RGB/COMPUTER
+
U T
SHIFT ZOOM FOCUS
–
D W
LENS
TEMP
EMERGENCY AV RGB
2, 1
OPERATE button
2, 1
The following describes the basic procedure for normal use of
the projector.

1. Turning on the Power

1 Turn on the MAIN POWER switch
of the projector.
ON [ ]:The main power turns on and the STAND BY
indicator comes on.
2 Press the OPERATE button for one
second or more.
(Or press the remote control's
OPERATE button for one second
or more.)
• The OPERATE indicator comes on.
• About 30 seconds after the MAIN POWER switch is
turned on, you can start projecting.
Remote control unit
OPERATE
Note
• After the power is turned on, the screen may be jumbled for a few
seconds, but this is not a malfunction.
Turning off the Power
1 Press the OPERATE button for one
second or more.
(Or press the remote control's
OPERATE button for one second
or more.)
• The STAND BY indicator changes to blinking, and the
projector goes into cool-down mode.
Example of the projector's button
OPERATE
2 Turn off the MAIN POWER switch
after the cooling fans have
stopped running.
OFF [‡ ‡ ‡ ‡ ‡ ]: The MAIN POWER switch turns off and the
STAND BY indicator goes off.
* Do not turn off the MAIN POWER switch during cool
down mode (the STAND BY indicator blinking). About
10 minutes after the STAND BY indicator comes on
steady (stand-by mode), the cooling fans (except the
one for the light-source lamp power supply) will stop,
and then turn off the MAIN POWER switch.
Projector's indicator
STAND BY
Projector
or
OPERATE
Projector
\
STAND BY
Projector
STAND BY
25