Verifying Your Connection - NETGEAR WNDR4000 - N750 WIRELESS DUAL BAND GIGABIT ROUTER Setup Manual

First, plug in and turn on the cable or DSL modem (if your modem has a backup battery, plug
1.
it back in). Wait 2 minutes.
Now, plug the power cord into your N750 wireless gigabit router and into a power outlet. Wait
2.
1 minute.
Last, turn on your computer. It might take several minutes for your router to establish a
3.
connection with your computer and your Internet provider.
For DSL customers, if software logs you in to the Internet, do not run that
software. You might need to go to the Internet Explorer Tools menu, select
Internet Options, and then click the Connections tab, where you can select
Never dial a connection.

Verifying Your Connection

Verify that your router is connected correctly by checking the wireless router status lights (as
illustrated in Figure
1
Figure 8
Check the N750 wireless gigabit router status lights to verify the following:
• Power. The Power light (1) should turn solid green. If it does not, see
Functions" on page
• Internet. The Internet port light (2) should be lit. If it is not, make sure that the Ethernet cable
is securely attached to the N750 wireless gigabit router Internet port and that the modem, and
that the modem is powered on.
• Operating Mode. The 2.4 GHz N/G-Band light (3) should be on; the 5.0 GHz N-Band light
(3) should be on.
Installing Your Wireless Router Manually (Advanced and Linux Users)
8.
2 3
27.
5
4
6
7
"Checking Basic Router
14