Dishwasher Installation - GE GDT550HSDSS Installation Instructions Manual

Built-in dishwasher
Hide thumbs Also See for GDT550HSDSS:
Table of Contents

Advertisement

Available languages

Available languages

Dishwasher Installation

STEP 1: PREPARATION
Locate the items in the installation package:
STEP 2: CHECK DOOR BALANCE
wood base, check the
door balance by opening
and closing the door.
if, when opened, it self
closes within 20° from
vertical, stays in position
from 20° to 70° and falls
fully open beyond 70°.
door and adjust both springs to the same tension setting to
correct balance.
Figure G
Tip: Make sure door opens and closes smoothly.
Check door opening and closing. If door does not open easily or
falls too quickly, check spring cable routing. The cable is held in
place by "shoulders" on the pulley. Check to be sure cable has
not slipped over the pulley shoulders and is routed as shown.
6
Door
closes
within
20°
Door stays in
position from
20° to 70°
Door falls fully
open beyond 70°
Make sure
pulley cable
is within
pulley
shoulders
STEP 3: REMOVE WOOD BASE,
INSTALL LEVELING LEGS
IMPORTANT
Damage will occur.
it on its back.
with a 15/16" socket wrench.
Figure H
approximately 1/2" from frame as shown.
STEP 4: REMOVE TOEKICK
Step 22.
Figure I
STEP 5: POSITION SOUND BARRIER
(on some models)
Skip this step if the sound
barrier is not assembled
to the dishwasher.
Lift the sound barrier and
tape to the door front with
masking tape. This will
hold the sound barrier up
and out of the way during
installation.
Approx.
1/2"
Remove 2
Toekick Screws
Sound Barrier
Tape
Bottom Front View

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents