Cisco AJ732A - MDS 9134 Fabric Switch Release Note page 34

Caveats
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
switch# show system reset-reason
--- reset reason for Supervisor-module 1 (from Supervisor in slot 1) ---
1) No time
Reason: Unknown
Service:
Version: 3.1(2)
or
switch# show system reset-reason
----- reset reason for Supervisor-module 1 (from Supervisor in slot 1) ---
1) At 203437 usecs after Fri Jul 4 18:32:02 2008
Reason: Watchdog Timeout
Service:
Version: 3.1(2)
Entering the show logging onboard command will contain a card uptime record with an uptime of
497 days.
Thu Sep 25 19:09:33 2008: Card Uptime Record
----------------------------------------------
Uptime: 42946218, 497 days 1 hour(s) 30 minute(s) 18 second(s)
Reset Reason: Unknown (0)
Card Mode..........................: Runtime
Workaround: This issue is resolved.
CSCso06144
•
Symptom: Under certain rare circumstances, where there are excessive packet drops in the fabric
for a given I/O, port software failure (or in other words, SME engine reset) may be seen due to a
race condition between the host side and target side error handling of the exchange. This issue has
been observed in stress test scenarios where there are packet drops in the host side and lot of target
check conditions for the same I/O.
Workaround: This issue is resolved.
• CSCso85603
Symptom: CPP SME may crash when the port software failure coincides with the forwarding of a
SCSI error response from the target.
Workaround: This issue is resolved.
• CSCsq20470
Symptom: If you have more than 7 SME modules in a switch, Fabric Manager Web Client hangs
when the cluster summary page is selected.
Workaround: This issue is resolved.
• CSCsq23079
Symptom: The snmp-server enable trap CLI command does not support enabling or disabling of
traps from the CISCO-IPSEC-PROVISIONING-MIB.
Workaround: This issue is resolved.
• CSCsq23098
Symptom: The snmp-server enable trap CLI command does not support enabling or disabling of
traps from the CISCO-IMAGE-UPGRADE-MIB.
Workaround: This issue is resolved.
Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(2)
34
OL-14116-10