Replacing the Antenna-In Connector
Procedure
1
Slide the antenna-in connector into the slot on the system-board shield.
2
Replace the hex nut that secures the antenna-in connector to the
system-board shield.
Postrequisites
1
Replace the system-board shield. See "Replacing the System-Board Shield" on
page 36.
2
Replace the back cover. See "Replacing the Back Cover" on page 20.
3
Replace the stand. See "Replacing the Stand" on page 18.
4
Replace the stand cover. See "Replacing the Stand Cover" on page 16.
5
Follow the instructions in "After Working Inside Your Computer" on page 13.
38
|
Antenna-In Connector