-Versacad 386 - Epson Endeavor Vga Utilities Manual

-VersaCAD 386

If you have not yet installed VersaCAD 386, follow the
instructions in your VersaCAD documentation to instaIl it, then
use these steps to install the VGA drivers:
1. Run the INSTALL program, described on page 6, to copy
the driver files into your VersaCAD program directory.
2. Log onto your VersaCAD program directory.
3. Type the following and press
AVGAP.EXE
This co mmand loads a protected-mode TSR driver for
VersaCAD 386. When it is loaded, you see this message:
GD540x/GD542x 800x600x16 (protected
mode) graphics driver installed.
Version 1.00 Interrupt 6B Hex
Copyright 1992
rights reserved.
4. Make a copy of the original VersaCAD 386 configuration file,
ENVIRO .CFG,and name the copy ENVIRO.OLD.
Use a text editor or word processing program that can save a
5.
file in ASCII format to edit the
following statements at the end of the screen parameters
section:
42 VGA Utilities
:
by Cirrus Logic Inc. All
. CFG file. Add the
E
NVIRO