Table of Contents
Advertisement
Reversing
Door
I
1 Be sure you have adequate swing area before reversing door.
Tools needed:
2
You will need a screw driver with a #2 square bit.
_
\
_i_,_-\
//'_'_\
3
Protect flat work surface, such as top of dryer or floor near dryer,
1'___)
with a soft cloth or towel.
___j-/
4
Be sure dryer is unplugged from power source!
ELECTRICAL
SHOCK HAZARD
Failure to disconnect
power source before serwcing
could result in personal injury or even death.
Screwdrwers
with
#2 square &
straight bit
A) Removing
Trim Ring
B) Removing
Door from Front Panel
1 Open door to 90 degree angle.
1 Reopen door to 90 degree angle.
2
Remove and save trim plug and long,
2
Remove 2 short, course-thread,
panhead
course-thread,
panhead screw,
screws.
3
4
Close door.
Rotate door trim approximately
_A"counter-
clockwise and pull ring away from door.
E:3
;"
/
"
_
,/"
'k\
3
4
While supporting door with the other hand,
remove 3 short, fine-thread,
counter-sunk
sc rew s.
Gently place door face down on flat, covered
work surface.
Advertisement
Table of Contents
