Documentation Updates - Cisco 3020 - Catalyst Blade Switch Release Note

Documentation Updates

Note
•
•
•
•
•
•
Documentation Updates
This section contains these documentation updates:
•
•
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(37)SE and Later
20
Cisco IOS is affected by the following vulnerabilities:
Processing ClientHello messages, documented as Cisco bug ID CSCsb12598
–
Processing ChangeCipherSpec messages, documented as Cisco bug ID CSCsb40304
–
Processing Finished messages, documented as Cisco bug ID CSCsd92405
–
Cisco has made free software available to address these vulnerabilities for affected customers. There
are workarounds available to mitigate the effects of these vulnerabilities.
This advisory is posted at http://www.cisco.com/warp/public/707/cisco-sa-20070522-SSL.shtml.
Another related advisory has been posted with this advisory. This additional advisory also
describes a vulnerability related to cryptography that affects Cisco IOS. This related advisory is
available at the following link:
http://www.cisco.com/warp/public/707/cisco-sa-20070522-crypto.shtml.
A combined software table for Cisco IOS is available to aid customers in choosing a software
releases that fixes all security vulnerabilities published as of May 22, 2007. This software table is
available at the following link:
http://www.cisco.com/warp/public/707/cisco-sa-20070522-cry-bundle.shtml.
CSCsg18176
When dynamic ARP inspection is enabled and IP validation is disabled, the switch no longer drops
ARP requests that have a source address of 0.0.0.0.
CSCsg30295
When you configure an IP address on a switch virtual interface (SVI) with DCHP and enable DHCP
snooping on the SVI VLAN, the switch SVI now obtains an IP address.
CSCsh92834
When trunk ports are participating in a Flex Link configuration, entering a shutdown or no
shutdown interface configuration command on the port no longer causes the switch to reload.
CSCsh92844
Online insertion and removal (OIR) of an SFP module no longer causes error-disabled ports to
change to Up or Standby states, resulting in lost data.
CSCsi00879
When IGMP snooping is enabled, multicast traffic no longer is dropped after a port channel interface
link flaps.
CSCsi30888
The switch no longer halts when configuring link-state tracking with EtherChannel downstream
ports or when booting up a switch already configured with link-state tracking with EtherChannel
downstream ports.
"Updates to Software Configuration Guide" section on page 21
"Updates to Getting Started Guide" section on page 21
OL-12577-03