Disassembly And Reassembly Of The Cap And The Magazine Section - Hitachi NT65MA3 - 2-1/2 Angled Finish Nailer Service Manual

Pull out the Roll Pin D4 x 14 [42] with the roll pin puller (4 mm (.157") dia.) so that Guide Plate (A) [33] and
Guide Plate (B) [31] can be disassembled.
Pull out the Roll Pin D3 x 20 [43] and the two Roll Pins D3 x 28 [54] with the roll pin puller (3 mm (.118") dia.)
so that the Lock Lever [34] and the Pushing Lever Guide [58] can be removed.
(b) Reassembly
Disassembly procedures should be followed in the reverse order and tighten the two Hex. Socket Hd. Bolts
M6 x 30 [32] after making the Blade Guide [37], Guide Plates (A) [33] and (B) [31] flush with the Body Ass'y
[30]. After assembly, check that Pushing Levers (A) [40], (B) [36] and the Adjuster [38] move smoothly.

10-5. Disassembly and Reassembly of the Cap and the Magazine Section

(1) Disassembly and reassembly of the cap (See Fig. 21.)
[Tool required]
Hex. bar wrench (4 mm)
(a) Disassembly
Remove the three Hex. Socket Hd. Bolts M5 x 16 [50] with the hex. bar wrench (4 mm) so that Cap (A) [49]
and Gasket (B) [48] can be removed.
(b) Reassembly
Disassembly procedures should be followed in the reverse order.
Gasket (B) [48]
Body Ass'y [30]
Fig. 21 Disassembly and reassembly of the cap
Hex. Socket Hd. Bolt M5 x 16 [50]
Cap (A) [49]
--- 26 ---