Advertisement
Operation
Important: This snowthrower is intended for outdoor, residential
use only. do not use it indoors or for commercial or industrial
purposes.
Connecting to a Power Source
To reduce the risk of electric shock, this appliance has a polarized
plug (i.e., one blade is wider than the other). Use only a polarized
plug, UL-listed (CSA certified in Canada) extension cord recommended
for outdoor use. A polarized plug will fit in a polarized cord only one
way. If the plug does not fit fully in the cord, reverse the cord. If it
still does not fit, purchase a polarized extension cord. If you have a
polarized extension cord and the extension cord plug does not fit fully
into the wall receptacle, reverse the plug. If it still does not fit, contact
a qualified electrician to install the proper outlet. Do not change the
appliance or extension cord plug in any way.
Use only an extension cord recommended for outdoor use.
Contact with water while operating the product could cause
electric shock, causing injury or death.
•
Don't handle the plug or the appliance with wet hands
or while standing in water.
•
Use only an extension cord recommended for outdoor
cold-weather use.
Extension Cord Length
100 feet
150 feet
Note: Do not use an extension cord over 150 feet.
Important: Check the extension cord frequently during use for
holes or cracks in the insulation. Do not use a damaged cord. Do
not run the cord through standing water or wet grass.
1.
Make a loop in the extension cord.
2.
Insert the loop through the hole in the back of the upper handle,
securing the loop around the hook.
Note: This helps to prevent you from accidently disconnecting the
extension cord from the appliance during operation.
Minimum Wire Gauge (A.W.G.)
16
14
3.
Connect the extension cord to the appliance electrical cord.
4.
Plug the extension cord into a wall outlet.
5.
Keep the area to be cleared free of stones, toys, or other foreign
objects which the rotor blades may pick up and throw. Such items
could be covered by snowfall and remain unnoticed.
Starting and Stopping
To start the Power Shovel, push the button on the side of the handle
grip and squeeze the trigger. To stop the product, release the trigger.
Operating Tips
•
Start the Power Shovel and tilt it forward until the scraper blade
contacts the ground. Push the Power Shovel forward at a
comfortable rate of speed, yet slow enough to clear the path
completely. The width and depth of the snow determines your
forward speed.
•
Direct the snow to the right or to the left by holding the Power
Shovel at a slight angle.
•
For the most efficient snow removal, throw the snow downwind,
and slightly overlap each swath.
•
If you need to clear snow from crushed rock or gravel, push down
on the handle to raise the scraper clear of loose material that the
rotor blades could throw.
•
The Power Shovel can remove snow up to 6 in. (15 cm) deep in
one pass. When clearing deeper drifts, hold the Power Shovel
by the upper and lower handles and use a swinging or sweeping
motion. Remove a maximum of 6 inches (15 cm) with each pass
and repeat as many times as required.
•
Keep the cord clear of obstructions, sharp objects, and rotor. Do
not pull sharply on the cord or abuse it in any manner. Frequently
inspect the cord for damage. If it is damaged, replace the cord.
•
Disconnect the extension cord after using the Power Shovel.
Hang the extension cord with the Power Shovel so it will not be
misplaced or damaged.
4
Advertisement
