Information Codes - Samsung DV365ETBGWR/A3 User Manual

troubleshooting
Lint on clothes
Garments still wrinkled after
Wrinkle-Away
Odors remain in clothing
after Refresh.
Water drips from the nozzle
when Steam-Care starts
Sprayed water is not visible
during Steam-Care

INFORMATION CODES

Information codes may be displayed to help you better understand what is occurring with your Dryer.
ERROR DISPLAY
tS
tO
dO
dE
dF
bE
bE2
od
hE
Et
FE
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
30_ troubleshooting
DV365-03064C_EN.indd Sec7:30 DV365-03064C_EN.indd Sec7:30
• Make sure the lint filter is cleaned before every load. With some loads
that produce high amounts of lint, it may be necessary to clean the
filter during the cycle.
• Some fabrics are lint producers (for example, a fuzzy white cotton
towel) and they should be dried separately from clothes that are lint
trappers(for example, a pair of black linen pants).
• Divide larger loads into smaller loads for drying.
• Check pockets thoroughly before washing and drying clothes.
• Small loads of 1 to 4 items work best.
• Load fewer garments.
• Load similar-type garments.
• Fabrics having strong odors should be washed in a normal cycle.
• This is steam condensation. The dripping water will stop after a short
time.
• Sprayed water is difficult to see when the door is closed.
MEANING
Clogged Lint Screen
Vent is restricted
Running the dryer with door open
Door is not closing properly
Unit detects a button is being
pressed for over 30secs or button is
stuck
Invalid Dry time
Invalid heating Temp
EEPROM is not communicating
properly
Invalid power source Frequency
SOLUTION
Clean the screen or vent.
If the problem continues call for service.
Close the door and then restart.
If the problem continues call for service.
Call for service.
Make sure a button is NOT being pressed
continuously. Try restarting the cycle.
If the problem continues call for service.
Call for service.
Call for service.
Try restarting the cycle.
If the problem continues call for service.
Try restarting the cycle.
If the problem continues call for service.
2012-06-07 2012-06-07 7:54:49 7:54:49