Cisco CSACSE-1111-K9 - Secure Access Control Server Solution Engine Installation Manual page 122

Commands
You can also use the set time command to enable an NTP server to synchronize the ACS SE. You can
configure one or more NTP servers by separating each NTP IP address entry with a space. For more
information, see
ntpsync, page
Example
The following command initiates the system time setting procedure:
set time
set timeout
To set the period, in minutes, after which the serial console will time out, use the set timeout command:
set timeout
Syntax Description
This command has a single argument: the number of minutes before timing out. If you enter the
command with no argument, the system prompts you for a value in minutes.
Example
The following command establishes a serial console timeout after10 minutes:
set timeout 10
show
To show the version of the ACS SE, system load status, ACS service status, IP configuration, system
time, and NTP settings, ACS SE hostname, DNS domain, and timeout value, use the show command:
show
Syntax Description
This command has no arguments or keywords.
Example
The following command lists ACS SE information:
show
shutdown
To shut down the appliance from the serial console, use the shutdown command:
shutdown
Syntax Description
This command has no arguments or keywords.
Installation Guide for Cisco Secure ACS Solution Engine 4.1
C-14
Setting the System Time and Date with NTP, page 4-20
C-7.
[ ]
minutes
Appendix C Command Reference
and the command reference
OL-9969-03