Maintenance And Troubleshooting; Resetting To Factory Defaults; Troubleshooting Tips - NETGEAR EVA2000 - Digital Entertainer Live User Manual

Resetting to Factory Defaults

There are two ways to restore factory defaults on your DE Live:
• Soft Restore – Resets the factory defaults, removes your user account, but preserves all
downloaded movies (both purchased and rented).
• Full Restore – Resets the factory defaults, removes your user account, and ALL downloaded
movies (both purchased and rented).
NETGEAR recommends that you use the Soft Restore for most purposes.
For more information about restoring factory defaults, see

Troubleshooting Tips

Here are some tips for correcting simple problems that might prevent you from connecting to the
Digital Entertainer Live.
Table 5-1. Connecting to the Digital Entertainer Live
Problem
The remote control does not
respond.
There is no audio or visual output. • Make sure that the Audio/Visual (RCA) cable is inserted completely
You are attempting to use an
HDMI to DVI converter.

Maintenance and Troubleshooting

Solution
Check to see if the battery is inserted correctly.
and firmly at both ends. You should feel it snap into the EVA2000 A/V
connector.
• Disconnect the power adapter and connect it again.
HDMI to DVI converters are not supported.
v1.0, September 2009
Chapter 5
"Factory Defaults" on page 4-5.
5-1