Epson AP-60 - Projector Sound Solution User Manual
User's guide
Hide thumbs
Also See for AP-60 - Projector Sound Solution:
- Installation manual (28 pages) ,
- Manual (5 pages) ,
- Brochure & specs (4 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Epson AP-60 - Projector Sound Solution
Summary of Contents for Epson AP-60 - Projector Sound Solution
- Page 1 AP-60 User’s Guide...
-
Page 2: Copyright Notice
Seiko Epson Corporation. The information contained herein is designed only for use with this Epson product. Epson is not responsible for any use of this information as applied to other equipment. -
Page 3: Important Safety Instructions
Important Safety Instructions To reduce the risk of electric shock, do not remove the cover. No user serviceable parts inside. Refer CAUTION: servicing to qualified personnel. These servicing instructions are for use by qualified service personnel only. To reduce the risk of CAUTION: electric shock, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. - Page 4 Be aware of the fact that listening to loud sound over a long period of time leads to hearing damage. • Epson accepts no responsibility for any of the components of this product falling due to the lack of strength of the ceiling or inadequate installation.
- Page 5 • Do not leave the system or the remote control with batteries inside a vehicle with the windows closed, in places where they will be exposed to direct sunlight, or in other places that may become extremely hot. Thermal deformation or technical malfunction may occur, which could result in fire. •...
- Page 6 • This product should be installed by a professional audio/video installer or other qualified professional. Epson cannot provide advice concerning construction practices or building codes in your area. • Prior to installing this product, read the installation instructions completely. Keep these instructions in an easily accessible place for future reference.
- Page 7 • Do not install this product where it may be subject to impact or vibration. • Do not install this product in direct sunlight or near a heater vent, fireplace, or other source of heat. • Do not install this product on a slanted ceiling. •...
-
Page 8: Table Of Contents
Contents Introduction ............... . 9 Getting Started . -
Page 9: Introduction
Introduction ® The Epson AP-60 is a sound enhancement system designed to turn your classroom or meeting room into a state-of-the-art learning center. With the AP-60’s innovative four speaker design, powerful amplifier, and wireless pendant microphone, your voice will be heard clearly in all areas of the classroom. You can also amplify the sound coming from other devices in your classroom, such as a computer, DVD player, or a portable audio device. -
Page 10: Getting Started
Getting Started The included remote control allows you to turn on both the AP-60 and your Epson projector, and adjust the volume. See these sections: • “Using the Remote Control” below • “Turning On the System” on page 11 •... -
Page 11: Turning On The System
Turning On the System Press the P power button on the AP-60 remote control. Press to turn on The power light on the AP-60 changes from orange to green. Power light When you’re done using the system, press the P power button on the remote control to turn off the system. Note If there is no audio signal detected for 60 minutes, the AP-60 automatically turns off to conserve energy. -
Page 12: Using The Microphone
Using the Microphone Place the microphone around your neck with the black emitter facing away from you. Adjust the neck strap so that the top of the microphone is just below your collarbone. Emitter Press the power button on the pendant microphone until it clicks into place. The power button turns green. Power button Note If the power button turns red or doesn’t illuminate, replace the batteries in the pendant microphone (see page 19 for... - Page 13 Verify that the light on the AP-60 is lit. The light should match the selector on the pendant Channel microphone. Mic lights Channel selector Adjust the microphone sensitivity by rotating the control wheel on the pendant microphone, if Gain necessary. Gain control wheel Note If your system has more than one microphone, make sure that each microphone is on a different channel.
-
Page 14: Adjusting The Volume
Adjusting the Volume Press the Volume buttons on the AP-60 remote control to adjust the master volume. – Press to turn volume up or down temporarily turn off all sound, press the button on the remote control. Press the button again to MUTE restore audio. -
Page 15: Additional Features And Adjustments
Additional Features and Adjustments Follow the steps in this chapter to connect external audio devices to the pendant microphone, connect a second microphone to the AP-60, and to adjust the audio levels from different audio sources. See these sections: • “Connecting External Audio Devices”... -
Page 16: Adding A Second Microphone
Adding a Second Microphone Follow the steps below to connect a second microphone to the AP-60. Check the channel selector switch on top of the pendant microphone and note what channel it’s set to. Channel selector Set the second microphone to the opposite channel and turn it on. Verify that the Mic light for the second microphone is illuminated on the AP-60. - Page 17 Press the Volume buttons on the AP-60 remote control to adjust the master volume as necessary. – Press to increase or decrease volume...
-
Page 18: Replacing Batteries
Replacing Batteries Follow the instructions in this chapter to replace batteries in the pendant microphone or remote control. Replacing Remote Control Batteries If the CMD light doesn’t flash on the AP-60 when you press a button on the remote control, you may need to replace the batteries. -
Page 19: Replacing Microphone Batteries
Replacing Microphone Batteries If the power button on the pendant microphone turns red or doesn’t illuminate, you may need to replace the batteries. Follow the steps below to replace the batteries in the pendant microphone. Open the battery compartment cover on the back of the pendant microphone and remove the old batteries. Insert 2 AA batteries and close the battery compartment cover. -
Page 20: Solving Problems
• “Problems Using the Pendant Microphone” on page 21 • “Problems Using the Remote Control” on page 21 If you cannot solve the problem on your own, contact Epson for help. Basic Operation Problems Problem Solution The system doesn’t turn on. -
Page 21: Problems Using The Pendant Microphone
AP-60. You may need to replace the remote control’s batteries (see page 18). Turn off nearby equipment that emits infrared energy, such as a radiant room heater. The remote control has been lost Contact Epson for help. or damaged. -
Page 22: Where To Get Help
Description of the problem, including computer, audio, or video configuration Purchase Accessories You can purchase projectors, screens, or other accessories from an Epson authorized reseller. To find the nearest reseller, call 800-GO-EPSON (800-463-7766). Or you can purchase online at www.epsonstore.com (U.S. sales) or www.epson.ca (Canadian sales). -
Page 23: Specifications
Specifications General Audio channels 2 channels monaural (front and rear) Rated power 2 × 30 W RMS Supported microphones 2 Audio inputs One RCA style connector and one 3.5 mm stereo-mini jack Audio output One 3.5 mm stereo-mini jack Remote Control Range 20 feet (6 meters) Batteries... -
Page 24: Notices
Notices FCC Compliance Statement For United States Users This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. -
Page 25: Warranty
U.S. Possessions). You are responsible for securely packaging the defective unit and returning it to Epson within five (5) working days of receipt of the replacement. Epson requires a debit or a credit card number to secure the cost of the replacement product in the event that you fail to return the defective one. - Page 28 Printed in XXX...