Removing A Power Supply - Cisco WS-X6148-GE-TX - Switch Hardware Installation Manual

Chapter 2 Installing the Cisco UCS 6100 Series Fabric Interconnect
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
You can replace a faulty power supply while the system is operating provided the other power supply is
Note
functioning.
This section includes the following topics:
•
•

Removing a Power Supply

Caution If you are using the Cisco UCS 6100 Series Fabric Interconnect with one power supply, removing the
power supply causes the system to shut down. If you are using two power supplies and you remove one
of them, the system continues to operate.
To remove a power supply, follow these steps:
Step 1 Ensure that the system (earth) ground connection has been made. For ground connection instructions,
see the
Step 2 Grasp the power supply handle with your left hand.
OL-20036-02
Removing a Power Supply, page 2-25
Installing a Power Supply, page 2-26
"Grounding the System" section on page 2-11.
Cisco UCS 6100 Series Fabric Interconnect Hardware Installation Guide
Replacing or Installing Components
2-25