Editing A Virtual Library; Creating Tape Drives - HP 12000 User Manual

12. Click Create Library.
A summary window opens and displays details about the library emulation created.
13. Choose one of the following options:
To perform LUN mapping for the virtual library, click Map LUNs and proceed to
Mapping" (page 91)
To continue creating the virtual library, click Create Tape Drives and proceed to
Tape Drives" (page
To exit the wizard, click Cancel.
The library is created but does not contain any tape drives or cartridges. You can add
tape drives and cartridges later.

Editing a Virtual Library

To edit the slots and drives of a virtual library, from Command View VLS:
1. Click the System tab.
2. Expand Chassis in the navigation tree.
3. Expand Virtual Libraries in the navigation tree.
4. Select the virtual library you want to edit.
5. Select Edit Virtual Library in the task bar.
6. On the Library Parameters screen, change the values as appropriate. You can change the
maximum number of slots, maximum number of ports, and maximum number of drives.
7. Select Next Step. The screen displays a confirmation.
8. Select Yes to continue. The screen displays a "success" message.

Creating Tape Drives

NOTE: If you add a virtual tape drive to a library after another library has been created, the
default LUN number assigned to the tape drive will not be consecutive with the other virtual tape
drives in the same library. To correct this, restart the VLS device emulations. See
Device Emulations" (page
the VLS so that all the default tape drive LUNs in a library are consecutive.
NOTE: A virtual library may only contain one type of tape drive.
To add tape drives to a virtual library:
1. If you are already in the Create Library Wizard window, click Create Tape Drives.
The Tape Drive Parameters window opens.
for further instructions.
97).
109). The VLS firmware will change the virtual device LUN numbers on
"LUN
"Creating
"Restarting VLS
Editing a Virtual Library 97