Pioneer S-LX70C Operating Instructions Manual page 159

The Initial Setup menu
Setting Options
D.TV Age Limit Next Screen
This setting is only applicable when the country is set to France, Denmark, Finland or Sweden.
HDMI Output
(only available when an HDMI device is connected)
Screen Resolution 1920 x 1080p
1920 x 1080i
1280 x 720p
720 x 576p
(720 x 480p)
720 x 576i
(720 x 480i)
If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case, press
holding down the (Stop) button on the front panel to switch the setting.
4:3 Video Output Full
Normal
Colour RGB (0–255)
RGB (16–235)
YCbCr 4:2:2
YCbCr 4:4:4
• Depending on the connected device some settings may not be available.
• When a DVI device is connected, the YCbCr 4:2:2 and YCbCr 4:4:4 options are not available.
Audio Output Auto •
PCM
Bitstream Priority
This setting is not available when a DVI device is connected
HDMI Control On •
Off
• For more information about HDMI Control, see HDMI Control on page 66.
• This setting is available even if you are not connected to an HDMI device.
• For more information, see Troubleshooting on page 168.
Explanation
Use this screen to enter an age limit for D.TV programmes. Programmes that
are broadcast with age suitability guidelines that fall above the age set here
will require the correct password to be entered before the channel can be
viewed.
You must also enter your password in order to change the age limit setting.
Constant 1920 x 1080p output.
Constant 1920 x 1080i output.
Constant 1280 x 720p output.
Constant 720 x 576p output (when setting the Input Line System to
525 System, video is output in 720 x 480p).
Constant 720 x 576i output (when setting the Input Line System to
525 System, video is output in 720 x 480i).
Select if your HDMI TV allows you to change the aspect ratio.
Select if your HDMI TV does not allow you to change the aspect ratio. 4:3
video will be shown with bars on each side.
Use if colours are weak and black appears to 'float' on the RGB (16–235)
setting.
Use this setting if colours appear overly rich and the black too deep on the
RGB (0–255) setting.
The video signal is output as a YCbCr 4:2:2 component signal. This is the
standard setting for HDMI-compatible devices.
The video signal is output as a YCbCr 4:4:4 component signal.
Dolby Digital, MPEG and DTS sources are output as a bitstream signal.
However, depending on the Audio Out setting, number of audio channels,
and the HDMI-connected device, Linear PCM audio may be output.
All audio signals are converted to Linear PCM (except DTS).
Select if the connected device is compatible with bitstream audio.
.
Enable the HDMI Control function. Select this option when using to an
HDMI Control-compatible Pioneer plasma television.
Disable the HDMI Control function. Select this option when not connected to
an HDMI Control-compatible component, or when connected to a
component manufactured by a company other than Pioneer.
15
OPEN/CLOSE while
159
En