Introduction; Warranty - DigiTech STUDIO 400 Owner's Manual

2

INTRODUCTION

Congratulations, and thank you for your purchase of the DigiTech Studio 400.
The Studio 400 gives you four completely independent inputs and outputs driven by proven Dual S-
DISC™ technology. The results are obvious: sparkling clean sound and endless combinations of effects
and signal path routings. Features include:
• Balanced 1/4" and XLR Inputs and Outputs
• Dual S-Discs
• Optional Digital I/O Interface
• 8 Effects at once
• 24 bit data path
• 191(Factory) 100(User) Programs
• Effects include: Reverbs, Choruses, Flangers, Auto-Panners, Tremolo,
Intelligent Pitch Shifting, Delays (Analog and Digital),
Rotary Speaker Simulator, Compressor, and Noise Gate.

WARRANTY

1. The warranty registration card must be mailed within ten days after purchase date to validate the war-
ranty.
2. DigiTech warrants this product, when used solely within the U.S., to be free from defects in materials
and workmanship under normal use and service.
3. DigiTech liability under this warranty is limited to repairing or replacing defective materials that show
evidence of defect, provided the product is returned to DigiTech WITH RETURN AUTHORIZATION,
where all parts and labor will be covered up to a period of one year. A Return Authorization number
may be obtained from DigiTech by telephone. The company shall not be liable for any consequential
damage as a result of the product's use in any circuit or assembly.
4. Proof-of-purchase is considered to be the burden of the consumer.
5. DigiTech reserves the right to make changes in design, and make additions or improvements to this
product without incurring any obligation to install the same on products previously manufactured.
6. The foregoing is in lieu of all other warranties, expressed or implied, and DigiTech neither assumes nor
authorizes any person to assume any obligation or liability in connection with the sale of this product. In
no event shall DigiTech or its dealers be liable for special or consequential damages, or from any delay
in the performance of this warranty due to causes beyond their control.
DigiTech™, Studio 400™, and S-DISC™ are registered trademarks of DOD Electronics Corporation.
IMPORTANT! The information contained in this manual is subject to change at any time without notification.
Some information in this manual may also be inaccurate due to undocumented changes in the
product or operating system since this version of the manual was completed. The information
contained in this version of the manual supersedes all previous versions.
Section 1 - Setting Up
Studio 400 Owner's Manual