First Things First; Mounting Procedure - GE 75350 User Manual

First Things First

Mounting procedure

1. If your cabinet does not have an
overhang:
(a) Position Template in desired location on
EN
underside of cabinet, flush with front
edge.
(b) Then tape Template in place, and go to
Step 2 (Read "Caution").
FRONT EDGE MOUNTING
OF CABINET
TEMPLATE
If your cabinet has an overhang:
(a) Measure the thickness of the overhang.
(b) Fold front of Template downward along
the printed guideline that is closest to
the thickness of your cabinet.
(c) Tape fold-down portion to backside of
overhang, Tape Template to cabinet
underside.
3
First Things First
MEASURE THICKNESS OF
CABINET OVERHANG
2. Drill
3. Remove Template and clean drill shavings
4. If your cabinet does not have an
FOLD TEMPLATE ON
DOTTED LINE
Note:
If your cabinet has glue blocks or other
obstructions, cut out corresponding areas on
the Template to clear them. Do not cut out or
cut through the screw holes indicated on the
Template.
It is recommended that safety glasses be worn
while drilling screw holes to prevent the
possibility of eye injury.
1 / -inch diameter holes through the
4
underside of the cabinet bottom shelf using
the 3 points marked on the Template.
from inside and underside of cabinet.
overhang, go to Step 5.
If your cabinet has an overhang, select the
spacer or combination of spacers that is equal
to or longer than the cabinet overhang.
Tips:
On wooden cabinets you may want to
mark and start the drill holes with a nail or an
awl.
Be sure to hold the drill very firmly against the
cabinet to reduce "walking" of the drill bit
from the markings.
Use masking tape above the hole locations on
inside of wooden cabinet shelf to help reduce
splintering.
If installing the unit under a wood cabinet,
you may wish to countersink the drilled hole
from the INSIDE of the cabinet if a countersink
attachment for your drill is available. This will
eliminate the use of washers and allow the
screw heads to be flush with the floor of your
cabinet. If you cannot countersink the holes,
use the supplied washers.
4
EN