Changing Camera Settings; Network Settings - Panasonic BL-C111A - Network Camera - Pan Operating Instructions Manual

5 Changing Camera Settings

5.1 Network Settings

The camera's network settings are made when configuring the camera according to the instructions provided
in the Setup Guide. You can change these settings later if necessary using the procedures described in this
section.
Note
•
You must log in to the camera as the administrator in order to change these settings.
•
After changing network settings and clicking [Save], the camera must be restarted. All buffered images
are deleted when the camera is restarted.
•
Ask your Internet Service Provider or network administrator for the appropriate network settings.
•
If you cannot access the camera after changing certain network settings, use the Setup Program to
confirm the camera's IP address (see Page 143) or reconfigure the camera as explained in the Setup
Guide.
•
If your network uses the IPv6 protocol, see Page 130.
5.1 Network Settings
Operating Instructions 81