When Installing The Antenna Inside The Vehicle (On The Dashboard Or Rear Shelf) - Pioneer AVIC-X930BT Installation Manual

Multimedia av navigation receiver
Hide thumbs Also See for AVIC-X930BT:
Table of Contents

Advertisement

Available languages

Available languages

Installation
When installing the antenna inside the vehicle (on the dashboard
or rear shelf)
WARNING
Do not install the GPS antenna over any sen-
sors or vents on the dashboard of the vehicle,
as doing so may interfere with the proper
functioning of such sensors or vents and may
compromise the ability of the metal sheet
under the GPS antenna to properly and se-
curely affix to the dashboard.
Affix the metal sheet on the surface as level as
possible where the GPS antenna faces the
window. Place the GPS antenna on the metal
sheet. (The GPS antenna is fastened with its
magnet.)
Metal sheet
GPS antenna
Peel off the protective sheet
on the rear.
Clamps
Use separately sold clamps
to secure the lead where necessary
inside the vehicle.
Make sure the surface is
free of moisture, dust,
grime, oil, etc., before
affixing the metal sheet.
Note
The metal sheet contains a
strong adhesive which may
leave a mark on the surface if
it is removed.
Section
03
25
En

Advertisement

Table of Contents
loading

This manual is also suitable for:

Avic-z130btAvic-x9310bt

Table of Contents