Advertisement
Operating your Breville Stainless Steel Kettle
Before first use
Remove and safely discard any packaging
material or promotional labels before using your
kettle for the first time. It is recommended before
the first use to fill the kettle to the maximum
level with cold tap water, bring to the boil then
discard the water. Your kettle will only operate
when positioned on the power base with the
ON/OFF switch in the ON position. The kettle will
automatically switch to the OFF position when the
water has boiled.
Operation of your kettle
1.
To fill the kettle with water, remove the kettle
from the power base and open the lid by
lifting up the safety locking hinged lid. Fill
with the desired amount of water.
2.
Ensure the lid is closed and locked securely
into place. Position the kettle firmly onto the
power base. Insert the power plug into a
230/240V power outlet and switch on.
3.
Press the ON/OFF switch down to the ON
position. The power ON light will illuminate.
Always fill the kettle with water between the
minimum (MIN) and maximum (MAX) marks on the
water window on the kettle. Too little water will
result in the kettle switching off. Filling above the
maximum mark (MAX) may result in boiling water
splashing from the kettle.
Do not remove the kettle from the power base
during operation. Ensure the kettle has switched to
the OFF position, after the water has boiled, before
removing the kettle from the power base.
4.
The kettle will automatically switch to the
OFF position when the water has boiled. Lift
the kettle from the power base and pour
the water. Take care to hold the kettle level,
especially when filled to the maximum (MAX)
level. To re-boil it may be necessary to wait
for a few seconds to allow the control to
reset.
5.
If further heating of the kettle is not required,
switch off at the power outlet, unplug the
power cord and empty the water from the
kettle. Replace the kettle onto the power base
and close the lid.
This kettle must be used with the power base
supplied. Use caution when pouring water from
your kettle, as boiling water and steam will scald.
Do not pour the water too quickly.
Always ensure the filter is properly placed back in
position before operating the kettle.
Safety boil dry protection
The kettle is fitted with a safety device, which
protects against overheating should the appliance
be operated with insufficient water. If this occurs
the kettle will stop heating and the illuminated
light on the power ON/OFF switch will go out.
Switch off at the power outlet and allow the kettle
to cool before refilling. Remove the kettle from
the power base and add cold water. Return kettle
to the power base. The safety device will then
automatically reset.
7
Advertisement
