Extend (Wpa-Psk Or Wpa2-Psk) Security; Connection Wizard: Step 3: Internet Configuration - ZyXEL Communications NBG-417N - V1.0 Manual

Note: The wireless stations and NBG-417N must use the same SSID, channel ID,
WPA-PSK (if WPA-PSK is enabled) or WPA2-PSK (if WPA2-PSK is enabled) for
wireless communication.

4.3.1 Extend (WPA-PSK or WPA2-PSK) Security

Choose Extend (WPA-PSK) or Extend (WPA2-PSK) security in the Wireless
LAN setup screen to set up a Pre-Shared Key.
Figure 14 Wizard Step 2: Extend (WPA-PSK or WPA2-PSK) Security
The following table describes the labels in this screen.
Table 10 Wizard Step 2: Extend (WPA-PSK or WPA2-PSK) Security
LABEL
Pre-Shared
Key
Back
Next
Exit
4.4 Connection Wizard: STEP 3: Internet
Configuration
The NBG-417N offers three Internet connection types. They are Ethernet, PPP
over Ethernet or PPTP. The wizard attempts to detect which WAN connection
type you are using. If the wizard does not detect a connection type, you must
select one from the drop-down list box. Check with your ISP to make sure you use
the correct type.
NBG-417N User's Guide
DESCRIPTION
Type from 8 to 63 case-sensitive ASCII or HEX characters. You can set up
the most secure wireless connection by configuring WPA in the wireless
LAN screens. You need to configure an authentication server to do this.
Click Back to display the previous screen.
Click Next to proceed to the next screen.
Click Exit to close the wizard screen without saving.
Chapter 4 Connection Wizard
43